To ensure the effectiveness of the powder molding machine
Author：adminDate：2018-03-16Views：2562
The first test, pressure regulator control should be placed on the 6 pointer, will fly into the bucket, the hand wheel rotation test by hand, and adjust the filling and pressure, meet the requirements of finished products increased gradually to the weight of the tablet and the soft and hard degree, and then start the motor, then the clutch, the formal operation of the production and in the production process, quality inspection is required in the whole tablet, it meets the requirements, adjust the necessary. Secondly, the choice of speed has a direct effect on the service life of the machine, due to the nature of the viscosity and sheet material size and pressure can not be unified in use, so the production speed is determined according to the actual needs of the general material, suitable for pressing slow minerals, plants, large size, poor viscosity and fast to the rapid molding material, suitable for pressing adhesive, good lubrication and easy molding material, so as to avoid equipment failure in production.
